Click on the 'Apple' in the upper left corner of your screen
Select 'Control Panels'
Select 'TCP/IP'

 

Click on the 'Apple' in the upper left corner of your screen
Select 'Control Panels'
Select 'TCP/IP'

 

Set the TCP/IP settings to:
    Connect via: Ethernet
    Configure: Manually
    IP address: 10.0.0.1
    Subnet mask: 255.0.0.0
    Router address: 10.0.0.138

Close and save these settings

 

Open your web browser (e.g. Internet Explorer).
Type 10.0.0.138 in the address bar and press Enter
Click on the the 'Advanced' menu on the left side of the page

 

Click on 'Setup'
Click on 'Browse'

 

Select the CD-Drive
Open the 'fscommand' folder
Select the file 'NZ_RTPPPoA_napt_dhcp_dns.ini'
Click 'Open'.

 

The file name should now be in the textbox next to 'Browse'
Click on 'Upload'

 

The message below should appear
Click on 'Accept'
Click on the 'Basic' menu on the left side of the page

 

Click on 'Connect' under the 'Basic' menu
Click on 'Disconnect'

 

Ensure that the Link and State are idle and down respectively
Enter your ISP username and password in the textboxes provided
Click on 'Connect'

 

Ensure that the Link and State are connected and up respectively (if they are not, there may be an error with the username or password, so click 'Disconnect' and try again)
Click 'Save All' and close then screen

 

Set the TCP/IP settings to:
    Connect via: Ethernet
    Configure: Using DHCP server

Close and save these settings
You should now be connected