Enhancing Broadband

The first step when installing the Speedtouch 330 modem is to install the software and drivers off the CD-ROM. To start the installation just insert the CD into the PC and the Installation process should start automatically.

Instructions:

1. Insert the Speedtouch CD

2. The wizard should auto-start with the window below.

3. Click on OK for English.

4. The Plug and Surf menu will now open as below. Click on 'Speedtouch USB/330 Software'.

5. Click on 'Install Software (NZ Settings)'.

6. The Setup wizard should open listing all of the supported Speedtouch devices. Click on 'Next'.

7. Click on 'Yes' to the licence agreement.

8. Click on 'Next' once the destination folder has been set. The default is
C:\Program Files\Thomson\SpeedTouch USB.

9. Click on 'Next' once the program folder has been set. The default is SpeedTouch USB.

10. The software will now be installed and after a few seconds the finish screen will appear as below. Click on 'Finish'.

11. Close the Plug and Surf menu.

12. Plug in the modem to any available USB port on the PC.

13. The found new hardware wizard should pop up and should automatically finish the installation process.

14. Plug one end of the the DSL/Phone line cable into the modem and the other either into a jack-point or into the modem side of a micro-filter. Ensure all other telephony devices on the same telephone number are also filtered.

15. After a few moments both lights on the modem should be solid green.

16. Double click on the 'Speedtouch Connection' icon on the desktop.

17. This will open the connection box as below.

18. Enter your username and password as supplied by your ISP and click on connect.

You should now have a Internet connection and be able to surf.

Start-up Phases and alert indications for the Speedtouch 330 modem can be viewed by clicking here.
The Speedtouch 330 Modem Diagnostic Guide can be viewed by clicking here.

Copyright of Connectplay Ltd.